8 Inch Hickenbottom Standpipe

Standpipe

This section contains 56 1" holes per foot and is used in standard conditions where an 8" inlet is needed for capacity.

8 Inch Hickenbottom Riser

Riser

This is a 8" x 5/16" holed orange section used underground from the tee as a riser extension. It can be cut at different locations (as marked on section) to adjust the height of inlet.

8 Inch Hickenbottom Tee

Tee

This is an 8" new style tee which can be used to connect directly to 8" corrugated or dual wall tile.

8 Inch Hickenbottom Restrictor

Restrictor

This is an 8" restrictor used to adjust the flow of water from the inlet to the main line.

6 to 8 Inch Hickenbottom Adapter

6" to 8"Adapter

This increaser adapts a 6" tee to a 8" riser section.

8 to 10 Inch Hickenbottom Adapter

8" to 10" Adapter

This increaser adapts a 8" tee to a 10" riser section.

Hickenbottom silt sock

SiltSock

Cubic feet / second Water Depth
1 ft
2 ft
3 ft
4 ft
5 ft
6 ft

Stock 8" Inlet with 56 ‐ 1" Holes/ft (ft3/s)

Stock 8" Inlet with 44 ‐ 1" Holes/ft & 8 - 1"x4" Slots/ft (ft3/s)

Water Depth Stock 8" Inlet with 56 ‐ 1" Holes/ft (ft3/s) Stock 8" Inlet with 44 ‐ 1" Holes/ft & 8 - 1"x4" Slots/ft (ft3/s)
1 ft 0.49 0.75
2 ft 1.39 2.1
3 ft 2.55 3.85
4 ft 3.92 5.93
5 ft 5.48 8.39
6 ft 7.2 10.9

The capacity charts are based on the following assumptions:

  • 50% of the holes in the inlet are plugged.
  • There is no flow through the top of the inlet. The top of the inlet i either capped or the top of the inlet extends above the water elevation.
  • The perforations in the inlet extend as high as teh water depth.
  • The flow in the inlet is not restrited by any other component of the system. For example, flow is not restricted due to an orifice plate, and offset pipe that limits flow, or full pipe lfow in the mainline that could create a tailwater effect in the inlet.